Dental LED Curing Light Wireless Blue Ray Curing Lamp 5W≥1200mw/c㎡ Wavelength 440-480nm Solidify Dentists Instrument

Dental LED Curing Light Wireless Blue Ray Curing Lamp 5W≥1200mw/c㎡ Wavelength 440-480nm Solidify Dentists Instrument

Description:

1. LED Screen，high quality plastic handle.
2. Noiseless and no vibration when working.
3. Lithium battery with large capacity
4. Three Modes: Gradually mode/Flashing mode/All light mode
5. Automatically power down: It will be turned automatically off automatically without pressing button for 3 minutes.
6. Solidification time is :40s. Every ten seconds, sound signal to remind operator. The length of work time can be controlled freely.
7. lt has self-protection against exceeding heat after continuous long time work that power – off by itself. After the temperature is normal, operator can use it again.
8. The LED is longevity. Cold light source, no fan. Avoid the infection, cause of air movement.

Feature:

1.Packing Size: 210*148*71 mm(unit)

2.Packing weight: 420g

3.Wavelength: 440-480nm

4.Light Intensity: 5W≥1200mw/c㎡

5.Input Voltage: 100-240V 50-60HZ

6.Battery Capacity: DC3.7v 2200mAh

7.Solidification Effect:5s/3mm

Operation Conditions:

1. Storage Condition: Temperature: +10℃+40℃

2. Humidity: 30%-75%

3. Atmospheric pressure: 70KPa-106Kpa

4. Environment Conditions: Not near from fire equipment or flammability material.

Operation Guide:

1. Power on/off.

When the unit is off or stand by, press “power” button to make the unit power on. If press “power” button continues for 2 seconds, the unit should be power off.

When the unit is power on, after select work mode press “power” button to make the unit working, the unit should be output blue light, press the button again, working stop and turn to be standby.

2. Mode select: press “mode” button to select three types of work modes.

“01” Mode: gradually strong mode, light intensity：800-1200mW/cm2, time setting: 10S, 20S, 30S, 40S;

“02” Mode: flashing mode, light intensity：800-1200mW/cm2, time setting: 10S, 20S, 30S, 40S;

“03” Mode: strong mode, light intensity：800-1400mW/cm2, time setting: 10S, 20S, 30S.

3. Time select press “time” button to select the time type. Four types of time:10/20/30/40 seconds can be chosen.

4. When the unit is working, the buzzer will beep every 5 seconds.

5. Automatically power down: when the unit is standby and without press button for 8 minutes, this unit will be turned off automatically.

6. Low battery alert: every time open the unit power, if the voltage of the battery is lower than the set point, this unit will be alarm. The buzzer beeps 5 times and the indicator flashes in the stage, please charge the battery in time.